Design, Development and Testing of a Prototype Hardware Module for Power and Phase Measurement of LHCD System
Keywords:
LHCD, Power measurement, Phase measurementAbstract
In this paper we present the design of a hardware module for measurement of power and phase of the 64 channels of the LHCD (lower hybrid current drive) system at 3.7GHz. The power measurement module uses a single IC, LTC5508. The output (in volts) from the IC is then mapped to obtain the power value in dBm and the same is displayed on a computer. Raspberry Pi is used to display the results on a computer in the form of a GUI (graphical user interface). The phase module however incorporates ICs namely, AD8302 (for phase measurement).
References
- Y. C. Saxena and SST-1 Team, “Present status of the SST-1 project,”422 Nucl. Fusion, vol. 40, no. 6, p. 1069, 2000.
- D. Bora, P.K. Sharma, S.L. Rao, R.G. Trivedi, M.K. Gupta, K. Ambulkar, K. Mishra,P.R. Parmar, K. Kumar, A. Thakur, Design criteria and current status of LHCDsystem on SST1 machine, Fusion Eng. Des. 82 (2007) 141–152, http://dx.doi.org/10.1016/j.fusengdes.2006.08.002
- P. K. Sharma et al., “Up gradation of LHCD system for RF power level 424 up to 2MW for SST1,” J. Phys., Conf. Series, vol. 208, no. 1, p. 012027, 425 2010.
- L. Qiang, L. Hao and Z. Yongzhao, Design of Hardware Implemented Phase Calculating System for Feedback control in the LHCD Experiments on EAST, Plasma Science and Technology, Vol. 11, No.2, pp. 241-244, 2009.
- LTC5508 datasheet, Linear Technology, CA, USA, 2001.
- AD8302 datasheet, Rev. A., Analaog Devices, Inc., Norwood, MA, USA, 2002.
Downloads
Published
Issue
Section
License
Copyright (c) IJSRSET
This work is licensed under a Creative Commons Attribution 4.0 International License.