Industrial Power Control ByIntegral Cycle Switching Without Generating Harmonics
Keywords:
Integral Cycle Control, Harmonics, Welding, high power factor, single phase induction motor, Control Strategies, MATLAB Simulation and Heating Application.Abstract
This paper present integral cycle switching control for industrial power control. In this method voltage control is achieved by connecting load to source for some – on cycle and then disconnecting some load for off-cycle. Principle of operation and circuit description are presented in this paper. The results are simulated using MATLAB SIMULING Integral Cycle control introduces less harmonica into the supply system.
References
- DV.Khakhkhar, " Design and Simulation of Novel Integral Switching Cycle Control for Heating Load", International Journal of Emerging Trends in Electrical and Electronics (IJETEE – ISSN: 2320-9569) , Vol. 5, Issue. 1, July-2013
- Bhagyashri S. Patil1, Prof. V.S.Pawar, " A Review on Conditioning and Monitoring of Non- Linear Load Electrical Load in the View of Power Quality”, International Journal of Advanced Research in Electrical, Electronics and Instrumentation Engineering (IJAREEIE), vol. 5, issue 4, April 2016.
- M H. Rashid, Power Electronics, 2nd ed. New Delhi, India: Prentice- Hall of India, 1988.
- Umar Farooq Siddiqui, Ajit Verma, and Shilpa Soni “Comparative Performance Analysis of Induction Motor Using Semiconductor Devices in Terms of Firing Angle,” International Journal of Emerging Technology and Advanced Engineering, Vol. 4, Issue 2, February 2014.
Downloads
Published
Issue
Section
License
Copyright (c) IJSRSET
This work is licensed under a Creative Commons Attribution 4.0 International License.