Effect of fault location on transient stability

Authors

  • Bhavik R Prajapati  Electrical Department, Sigma Institute of Engineering, Vadodara, Gujarat, India
  • Sagar G Ramanuj  Electrical Department, Sigma Institute of Engineering, Vadodara, Gujarat, India
  • Jay M Patel  Electrical Department, Sigma Institute of Engineering, Vadodara, Gujarat, India
  • Anish A Rana  Electrical Department, Sigma Institute of Engineering, Vadodara, Gujarat, India
  • Tabrejalam S Ansari  Electrical Department, Sigma Institute of Engineering, Vadodara, Gujarat, India

Keywords:

This paper shows an analysis of the effect of three phase to ground fault on the transient stability for the enhancement of power system using ETAP software, Transient stability is an important aspect in designing and upgrading electric power system after major failures cause by power system instability. The goal of transient stability analysis of power system is to analyze the stability of a power system in a time domain of a few seconds to few minutes using ETAP software.

Abstract

This paper shows an analysis of the effect of three phase to ground fault on the transient stability for the enhancement of power system using ETAP software, Transient stability is an important aspect in designing and upgrading electric power system after major failures cause by power system instability. The goal of transient stability analysis of power system is to analyze the stability of a power system in a time domain of a few seconds to few minutes using ETAP software.

References

  1. Pranamita Basu, Aishwarya Harinandan “Power system Stability analysis using matlab” from NIT Rourkee,p. 15-16
  2. LP.Singh, “ Advance Power system Analysis & Dynamics”,p.344
  3. MMoechtar ,T.C.Cheng, and L. Hu “Transient Stability of Power System a survey,” WESCON/95.conference record “Microelectronics communications Technology producing quality products Mobile & portable power emerging Technologies” SanFrancisco,Nov 1995,p166-171
  4. Wehnekel L.,Van Custem and Ribbens,“An Artificial intelligence frame work for online Transient stability assessment power system”,1984,4,(2),p.789-800
  5. SKrishna and K. R. Padiyar ”Transient stability assessment using artificial neural networks”proc.IEEE International conference on Industrial Technology 2000,Goa,India,vol.2,p.627-632.
  6. AH. El-Abiad and K. Nagappan “Transient Stability regions of multimachine power system”,IEEE Trans.power appar.syst.,1966,PAS-85,(2),169-178.
  7. MA.Pai “Energy function analysis for power system”, Kluwer academic publisher Boston 1989
  8. HD. Chiang, F.F. Wu and P.P. Varaiya “Foundations of direct methods for power system Transient stability analysis,” IEEE Trans. circuits and systems,1987,CAS-34,(2),p.160-173
  9. HD. Chiang, C.C. Chu and G. Cauley “Direct stability analysis of electric power systems using energy function” IEEE ,Nov 1995,vol 83,(11),p1497-1529.
  10. Leonard L. Grigsby “Power system stability and control,” chapter 8
  11. www.etap.com

International Journal of Scientific Research in Science, Engineering and Technology

Downloads

Published

2018-04-10

Issue

Volume 4, Issue 5, March-April-2018

Section

Research Articles

License

Copyright (c) IJSRSET

Creative Commons License

This work is licensed under a Creative Commons Attribution 4.0 International License.

How to Cite

[1]
Bhavik R Prajapati, Sagar G Ramanuj, Jay M Patel, Anish A Rana, Tabrejalam S Ansari, " Effect of fault location on transient stability, International Journal of Scientific Research in Science, Engineering and Technology(IJSRSET), Print ISSN : 2395-1990, Online ISSN : 2394-4099, Volume 4, Issue 5, pp.806-809, March-April-2018.