Design and Analysis of Counter shaft using CATIA and ANSYS

Authors

  • Pullareddy. M  M.Tech Student, CAD/CAM, Department of Mechanical Engg., PVKK Institute of Technology, Ananthapuramu, Andhra Pradesh, India
  • Chanikya. K  M.Tech Student Advanced Manufacturing Technology, Dept. of Mechanical Engineering, JNT University Ananthapuramu, Andhra Pradesh, India
  • Rajesh. B  M.Tech Student Advanced Manufacturing Technology, Dept. of Mechanical Engineering, JNT University Ananthapuramu, Andhra Pradesh, India
  • Sudheerreddy. J  Assistant Professor, Department of Mechanical Engineering, GATES Institute of Technology, Ananthapuramu, Andhra Pradesh, India
  • Mohanachari. J. V  M.Tech Student, CAD/CAM, Department of Mechanical Engg., PVKK Institute of Technology, Ananthapuramu, Andhra Pradesh, India

Keywords:

Countershaft (lay shaft),4340 Alloy steel(Heat treated),Stress, Strain

Abstract

The Recent advancement in software applications is making a best analysis results for the Mechanical Engineering application studies. This paper mainly involves with the designing and analyzing the countershaft (lay shaft) model by using the software application. This project deals with the stress analysis of a shaft using Ansys. The shaft which is fixed at one end is selected and forces are given at particular points. The reactant forces acts in opposite directions. Torque acts at two points in opposite directions. The reactant forces and bending moments are initially calculated. Based on these parameters, the maximum shear stress, normal stress is calculated. The same values are used then calculated by using ANSYS software. Finally the theoretical and analytical results are compared and verified. Here we selected for part design in CATIA V5R19 and for the analyzing the part model using the is Ansys 16.0 software respectively. Selection of material for the counter shaft is 4340 Alloy steel(Heat treated).

References

  1. Joseph E. Shigley, “Mechanical engineering design”
  2. Design Data Hand Book for Mechanical Engineers K
  3. Mahadevan K.Balaveera Reddy Chapter 3 pg 56
  4. “Fundamentals of machine design” BY T.J. Prabhu.
  5. Kurmi, R.S., “A Textbook of Machine
  6. “Strength of materials” by R.K. Bansal.
  7. Automobile Engineering Vol. 1 by Dr. Kirpal Singh

International Journal of Scientific Research in Science, Engineering and Technology

Downloads

Published

2016-10-31

Issue

Volume 2, Issue 5, September-October-2016

Section

Research Articles

License

Copyright (c) IJSRSET

Creative Commons License

This work is licensed under a Creative Commons Attribution 4.0 International License.

How to Cite

[1]
Pullareddy. M, Chanikya. K, Rajesh. B, Sudheerreddy. J, Mohanachari. J. V "Design and Analysis of Counter shaft using CATIA and ANSYS " International Journal of Scientific Research in Science, Engineering and Technology (IJSRSET), Print ISSN : 2395-1990, Online ISSN : 2394-4099, Volume 2, Issue 5, pp.473-476, September-October-2016.