Development of Front End Electronics for Nuclear Spectrometer

Authors

  • Vaishnavi G  Department of Physics, Anna University, Chennai, Tamilnadu, India
  • Dipak Kumar Panda  Dipak panda Kumar, Physical Research Laboratory, Ahmedabad, Gujarat, India
  • Velraj G  Department of Physics, Anna University, Chennai, Tamilnadu, India

Keywords:

Preamplifier, Multisim, Noise Measurement, PMT, Spectrometer.

Abstract

Gamma Ray spectrometer is an instrument to be used for measurements of elemental abundance of elements like Si, Mg, Ca, Ti, Fe, Al, K, U, and Th etc. We have developed the front end electronics for this spectrometer. Various types of detector are used for the gamma ray spectrometer. In this paper we have discussed the development design and its simulation results. In the current design we have used an low cost, high bandwidth and high slew rate to minimize the noise.

References

  1. Niharika Sukhani and Prakash vaidya, simulation of charge sensitive preamplifier using multisim software, India. April 2015 
  2. ORTEC Preamplifier introduction.
  3. M. Nazrul Islam, T.Fujiwara, Design and Development of a charge-sensitive Preamplifier for Nuclear Pulse Processing.
  4. Datasheet LT1252, Linear Technology.
  5. pulse processing :preamplifier  and noise, nuclear instrumentation.

International Journal of Scientific Research in Science, Engineering and Technology

Downloads

Published

2017-10-31

Issue

Volume 3, Issue 6, September-October-2017

Section

Research Articles

License

Copyright (c) IJSRSET

Creative Commons License

This work is licensed under a Creative Commons Attribution 4.0 International License.

How to Cite

[1]
Vaishnavi G, Dipak Kumar Panda, Velraj G "Development of Front End Electronics for Nuclear Spectrometer" International Journal of Scientific Research in Science, Engineering and Technology (IJSRSET), Print ISSN : 2395-1990, Online ISSN : 2394-4099, Volume 3, Issue 6, pp.986-991, September-October-2017.