Study on Steel Fiber and Fly Ash Using in Paver Block

Authors

  • Mayur Ashok Patil  Department of Civil engineering, Savitribai Phule, Pune University, Pune, Maharashtra, India
  • Prof. Dr. Nagesh Shelke  Department of Civil engineering, Savitribai Phule, Pune University, Pune, Maharashtra, India

Keywords:

Paver Blocks, Steel Fiber, Fly Ash, Conventional Blocks, Compressive Strength.

Abstract

Interlocking Concrete Block Pavement (ICBP) has been extensively used in many countries for quite some time as a specialized problem-solving technique for providing pavement in areas where conventional types of construction are less durable due to many operational and environmental constraints. ICBP technology has been introduced in India in construction, a decade ago, for specific requirement namely footpaths, parking areas etc. but now being adopted extensively in different uses where the conventional construction of pavement using bituminous mix or cement concrete technology is not feasible or desirable. This paper presents

References

  1. S. Revathi, Dr.R.Kumutha, Dr.K.Vijai, “Properties of Paver blocks with Groundnut Hush ash as Fine Aggregates”, International Research Journal of Engineering and Technology, Vol. 02, Issue 02, May 2015.
  2. Joel Santhosh, RavikantTalluri, “Manufacture Of Interlocking Concrete Paving Blocks With Fly Ash And Glass Powder”, International Journal of Civil Engineering and Technology, pp. 55-64, Vol. 6, Issue 4, April (2015).
  3. R. C. Yeole, Dr. M. B.Varma, “Comparison of mix designs of paver blocks using waste rounded Steel Aggregates and Rubber Pad”,International  Journal Of Engineering Technology and Advanced Engineering, Vol.4, Issue 10, Oct. 2014.
  4. SomNathSachdeva, VanitaAggarwal, S. M. Gupta, “High volume Fly ash concrete for paver blocks”, International Journal of Civil, Environmental, Structural, Construction and Architectural Engineering,Vol. 8, No.3, 2014.
  5. B.K. Kashiyani, Prof. J.Pitroda, Dr. B.K.Shah, “Effect on Polypropylene fibers on Abrasion Resistance and Flexural Strength for interlocking paver block”,Volume4,Issue 5,International Journal of Engineering Trends and Technology,May 2013.
  6. Aaron Darius Vaz, Donal Nixon D’Souza, NoothanKaliveer, Satish K.T and Amar S.M., “Geopolymer Paver Blocks”Proc. of Int. Conf. on Advances in Civil Engineering 2012.
  7. Radhikesh P. Nanda, Amiya K. Das, Moharana.N.C, “Stone crusher dust as a fine aggregate in Concrete for paving blocks”, International Journal of Civil and Structural engineering, Vol.1, No 3, 2010.
  8. Karasawa A., Suda S., Naito H. and Fujiwara H., “Application of fly ash to Concrete paving block”,Research and Development Centre, Taiheiyo Cement Corporation, Japan.
  9. Ganesh Tapkire, Satishparihar, PramodPatil, Hemraj R Kumava,“Recycled Plastic used in concrete Paver block”,International Journal of Research in Engineering and Technology, pp 2321-7308Vol.3,Issue 9,June 2014.
  10. Falah A. Almottiri, “Physical Properties of Steel Fiber Reinforced Cement Composites Madewith Fly Ash”, Jordan Journal of Civil Engineering, Volume 5, No. 2, 2011.
  11. IS 15658-2006, “Precast concrete blocks for paving”, Bureau of Indian Standards, New Delhi, India.

International Journal of Scientific Research in Science, Engineering and Technology

Downloads

Published

2017-12-31

Issue

Volume 3, Issue 8, November-December-2017

Section

Research Articles

License

Copyright (c) IJSRSET

Creative Commons License

This work is licensed under a Creative Commons Attribution 4.0 International License.

How to Cite

[1]
Mayur Ashok Patil, Prof. Dr. Nagesh Shelke "Study on Steel Fiber and Fly Ash Using in Paver Block" International Journal of Scientific Research in Science, Engineering and Technology (IJSRSET), Print ISSN : 2395-1990, Online ISSN : 2394-4099, Volume 3, Issue 8, pp.374-377, November-December-2017.