Protection of 220KV Transmission Line During LLLG Fault using PSB and OST Unit in MATLAB

Authors

  • Roshni Rahangdale  Department of Electrical Engg SSGI(SSTC) Bhilai, Durg, Chhattisgarh, India
  • Archana Gupta  Department of Electrical Engg. BIT,Durg, Durg, Chhattisgarh, India

Keywords:

Contingency, Relay, Power Swing, Faults, Distance Relay.

Abstract

Contingency analysis of any Power system involves studying the behavior of the Power System when applying to disturbance or any abnormal condition. This project involves the study of methods to detect Power Swing on a transmission line and verification of methods to detect Power Swing based on rate of change in Impedance. Here, Software is required for such analysis because in practical cases networks are very complicated and for the same system, modeling the entire component according to real system facilitates easier approach to study the same network without imposing it to practical condition. So to maintain system stability such contingency analysis plays vital role. A three area Power System model is designed in SIMULINK software and simulated data is used for analysis in this paper. Impedance seen by Distance Relay enters zone which is set generally 90% of transmission line impedance within one-cycle and it will be almost stable at Impedance equal to fault Impedance seen by relay. Whereas in case of Power Swing Impedance changes slowly and takes longtime to enter zone settings. So, using this method, we can detect Fault within one -cycle. If Impedance is changing slowly, we can block relay from operation.

References

  1. Majid Sanaye-Pasand and Ali Naderian Jahromi ,"Study, Comparison and Simulation of Power System Swing Detection and Prediction Methods", 0-7803-7989-6/03/$17.00 02003 IEEE
  2. Xiangning Lin, Yan Gao, and Pei Liu, "A Novel Scheme to Identify Symmetrical Faults Occurring During Power Swings". IEEE Trans. On Power Delivery, vol. 23, no. 1, January 2007.
  3. Edith Clarke, "Impedance Seen by Relay during Power Swing With and Without Faults", AIEE Trans., pp.372-384.
  4. A. R. Van C. Warrington, "Graphical Method for Estimating the Performance of Distance Relays during Faults and Power Swings," AIEE Trans.vol. 68 (1949), pp. 660-672.
  5. Liancheng Wang and Adly A. Girgis, "A New Method for Power System Transient Instability Detection", IEEE Transactions on Power Delivery, Vol. 12, No. 3, pp.1082-1089 , July 1997.
  6. J. Blumschein, Y. Yelgin, and M. Kereit, "Proper detection and treatment of power swing To reduce the risk of Blackouts", DRPT2008 6-9 April 2008 Nanjing Chin,pp.2440-2446.
  7. Dali Wu, Xianggen Yin , Zhe Zhang, and Kanjun Zhang, "Research on Improved Fault Classification Scheme during Power Swing", UPEC 2007,pp. 296-299.
  8. Hiroyuki Amano, Teruhisa Kumano, and Toshio Inoue, "Nonlinear Stability Indexes of Power Swing Oscillation Using Normal Form Analysis", IEEE Trans. On Power Systems, Vol. 21, No.2, pp. 825-833, May 2006 .
  9. Rudra Pratap, "MATLAB -7",Oxford University,0195179374 RG

International Journal of Scientific Research in Science, Engineering and Technology

Downloads

Published

2018-02-28

Issue

Volume 4, Issue 6, January-February-2018

Section

Research Articles

License

Copyright (c) IJSRSET

Creative Commons License

This work is licensed under a Creative Commons Attribution 4.0 International License.

How to Cite

[1]
Roshni Rahangdale, Archana Gupta, " Protection of 220KV Transmission Line During LLLG Fault using PSB and OST Unit in MATLAB, International Journal of Scientific Research in Science, Engineering and Technology(IJSRSET), Print ISSN : 2395-1990, Online ISSN : 2394-4099, Volume 4, Issue 6, pp.105-113, January-February-2018.