Optimization Milling Process When Machining C45 Steel by Ball Nose Mill for Minimum Tool Wear using Taguchi Method

Authors

  • Vu Nhu Nguyet  Faculty of Mechanical Engineering, Thai Nguyen University of Technology, Vietnam
  • Do Duc Trung  Faculty of Mechanical Engineering, Hanoi University of Industry, Ha Noi, Vietnam

DOI:

https://doi.org/10.32628/IJSRSET196188

Keywords:

Milling, Ball Nose Mill, Tool Wear, C45 Steel, Taguchi Method.

Abstract

In this paper, Taguchi method with L16 was used to experimental research in order to present the influence of cutting parameters and feed way on the tool wear when machining C45 by ball nose mill. The experimental result shows the influence of above parameters on tool wear and the value of cutting parameters and feed way for minimum of tool wear.

References

  1. Basim A. Khidhir and Bashir Mohamed, (2011) ,Analyzing the effect of cutting parameters on surface roughness and tool wear when machining nickel based hastelloy - 276, IOP Conf. Series: Materials Science and Engineering 17, doi:10.1088/1757-899X/17/1/012043.
  2. Duong Xuan-Truong and Tran Minh-Duc, (2013), Effect of cutting condition on tool wear and surface roughness during maching of Inconel 718, International Journal of Advanced Engineering Technology, pp.108-112.
  3. Ali Abbar Khleif and Mostafa Adel Abdullah, (2016), Effect of Cutting Parameters on Wear and Surface Roughness of Stainless Steel (316L) Using Milling Process, Al-Nahrain University, College of Engineering Journal (NUCEJ) Vol.91 No.2, 6192 pp.286 - 292.
  4. Ali Riza Motorcu, Abdil Kus, R?dvan Arslan, Yücel Tekin, R?dvan Ezenta?, (2013),Evaluation of tool life - tool wear in milling of inconel 718 superalloy and the investigation of effects of cutting parameters on surface roughness with Taguchi method, Tehni?ki vjesnik 20, 5, pp.765-774.

International Journal of Scientific Research in Science, Engineering and Technology

Downloads

Published

2019-02-28

Issue

Volume 6, Issue 1, January-February-2019

Section

Research Articles

License

Copyright (c) IJSRSET

Creative Commons License

This work is licensed under a Creative Commons Attribution 4.0 International License.

How to Cite

[1]
Vu Nhu Nguyet, Do Duc Trung "Optimization Milling Process When Machining C45 Steel by Ball Nose Mill for Minimum Tool Wear using Taguchi Method" International Journal of Scientific Research in Science, Engineering and Technology (IJSRSET), Print ISSN : 2395-1990, Online ISSN : 2394-4099, Volume 6, Issue 1, pp.476-479, January-February-2019. Available at doi : https://doi.org/10.32628/IJSRSET196188