Electrical Vehicle Speed Limiter using RF Technology

Authors

  • U. Subha  Assistant Professor EEE Department, Raghu Institute of Technology, Visakhapatnam, Andhra Pradesh, India
  • G. Joga Rao  Associate Professor EEE Department, Raghu Institute of Technology, Visakhapatnam, Andhra Pradesh, India
  • G.A.V. Durga Prasad  B. Tech EEE Department, Raghu Institute of Technology, Visakhapatnam, Andhra Pradesh, India
  • A.H. Naga Priya  B. Tech EEE Department, Raghu Institute of Technology, Visakhapatnam, Andhra Pradesh, India
  • G. Venkata Akhil  B. Tech EEE Department, Raghu Institute of Technology, Visakhapatnam, Andhra Pradesh, India
  • G. L. Sai Kumar  B. Tech EEE Department, Raghu Institute of Technology, Visakhapatnam, Andhra Pradesh, India
  • Y. D. V. S Prasanth  B. Tech EEE Department, Raghu Institute of Technology, Visakhapatnam, Andhra Pradesh, India

DOI:

https://doi.org/10.32628/IJSRSET196264

Keywords:

RF Module, Arduino, HT12E, HT12D, IR Obstacle Avoidance Sensor, Relays, DC Gear Motor, LCD Display.

Abstract

The objective of the project is to provide speed limitation to the electrical vehicle as per the speed sign boards. The system uses the RF (Radio Frequency) communication between speed sign post and the vehicle control system. Whenever a vehicle comes in range of the RF speed sign post, the sign post transmits the speed limit for that particular road to the vehicle system. The vehicle controller system receives this signal through RF receiver and processed through the microcontroller. If the system was at lower speed than the limit received from the sign post, then there will be no changes made to the speed of the system. If the speed of the vehicle was manually incremented to a higher value, then the controller will impose the speed restriction and bring back the speed value to the value specified by the limit. Now if the user tries to increase the speed, the system does not allow it to do so till it is in range of the RF speed sign post. The speed of the vehicle and the limits are displayed on an LCD.

References

  1. Ankita Mishra, Jyoti Solanki “Design of RF based speed control system for vehicles,” International Journal of Advanced Research in Computer and Communication Engineering, Vol. 1, No 8, 2012.
  2. Vinod Rao, Saketh Kuma, “SmartZone Based Vehicle Speed Control Using RF and Obstacle Detection and Accident Prevention, International Journal of Emerging Technology and Advanced Engineering, Vol.4, No.3, 2014.
  3. Gummarekula Sattibabu, Satyanarayan, “AutomaticVehicle Speed Control With Wireless In-Vehicle RoadSign Delivery System Using ARM 7,” InternationalJournal Of Technology Enhancements And EmergingEngineering Research, Vol 2, No. 8, 2014.
  4. Deepa B Chavan, Abdul Rahim Makandar,“Automatic Vehicle Speed Reduction System UsingRf Technology,” International Journal of EngineeringResearch and Applications, Vol.4, No.4, 2014.
  5. Jyothi Kameswari, Satwik , “A Design Model for Automatic Vehicle Speed Controller,” International Journal of Computer Applications, Vol.35, No.9, 2011.

International Journal of Scientific Research in Science, Engineering and Technology

Downloads

Published

2019-04-30

Issue

Volume 6, Issue 2, March-April-2019

Section

Research Articles

License

Copyright (c) IJSRSET

Creative Commons License

This work is licensed under a Creative Commons Attribution 4.0 International License.

How to Cite

[1]
U. Subha, G. Joga Rao, G.A.V. Durga Prasad, A.H. Naga Priya, G. Venkata Akhil, G. L. Sai Kumar, Y. D. V. S Prasanth "Electrical Vehicle Speed Limiter using RF Technology" International Journal of Scientific Research in Science, Engineering and Technology (IJSRSET), Print ISSN : 2395-1990, Online ISSN : 2394-4099, Volume 6, Issue 2, pp.274-279, March-April-2019. Available at doi : https://doi.org/10.32628/IJSRSET196264