Design of Piezoelectric Energy Harvester and Power Conditioning

Authors

  • D. Meena  Department of EEE, Krishnasamy College of Engineering and Technology, Cuddalore, Tamil Nadu, India
  • P. Jegan  Department of EEE, Krishnasamy College of Engineering and Technology, Cuddalore, Tamil Nadu, India
  • R. Puviyarasan  Department of EEE, Krishnasamy College of Engineering and Technology, Cuddalore, Tamil Nadu, India
  • R. Sathish  Department of EEE, Krishnasamy College of Engineering and Technology, Cuddalore, Tamil Nadu, India

DOI:

https://doi.org/10.32628/IJSRSET2072102

Keywords:

Embedded System, DSP, Piezoelectric, Power Conditioning, Energy Harvesting

Abstract

The existing system presents a novel approach called simultaneous wireless strain sensing and energy harvesting from multiple piezo-patches, which is intended for self-powered Structural Health Monitoring applications. The Energy Harvesting subsystem is mainly the self-powered extended synchronous electric charge extraction interface based on double cross-coupled rectifying structure and a single fly back transformer, which is able to harvest energy from multiple piezo-patches. In this proposed work, the DC power is generated using piezoelectric and MEMS. Then the Produced by DC energy is given to Ultra Low Power Converter Using with Micro controller then Ultra capacitor used to Highly Discharging in the DC power bank. The outputs of transducers are also given to micro controller. The obtained energy is boosted up using Booster Ultra Low Power Converter. The output of the Ultralow Power Converter is given to the Relay for the switching unit to store energy in a DC Power Bank and the stored energy is inverted to AC voltage

References

  1. B. Mitchell, "Energy harvesting applications and architectures at Boeingcommercial airplanes," NanoPower Forum, San Jose, CA,USA, 2007.
  2. L. G. dos Santos, "EMBRAER perspective on SHM introduction intocommercial aviation programs," in Proc. 8th Int. Workshop Struct. HealthMonitoring, Stanford, CA, USA, 2011, vol. 11, pp. 19–26.
  3. Ultra electronics aircraft systems. (Jul. 2010). [Online]. Available:www.ultra-electronics. com/ aircraft_systems/airframe_fatigue.php
  4. D. Meekhun, et al, "Design of a solar harvester system for a wireless sensor network deployed for large aircraft in-flighttests, " Renewable Energy Power Quality J., no. 6, pp. 856-1–856-2, Apr.2012.
  5. R.Montheard, et al., "Proof of concept of energy harvestingfrom aero acoustic noise," in Proc. PowerMEMS,Atlanta, GA, USA, 2012, pp. 267–270.
  6. D. Meekhun, et al., "Charge and discharge performanceof secondary batteries according to extreme environment temperatures," in Proc. IEEE 35th Annu. Conf. Ind. Electron. Soc., Porto, Portugal, Nov. 2009, pp. 271–275.
  7. N. Bailly, et al., "Energy scavenging based on transient thermal gradients: Applicationto structural health monitoring of aircrafts," in Proc. PowerMEMS,Sendai, Japan, Nov. 2008, pp. 205–208.
  8. D. Samson, et al., "Energy harvesting for autonomous wireless sensor nodes in aircraft," in Proc. EurosensorsXXIV, Linz, Austria, Sep. 2010, pp.1160–1163.
  9. M. E. Kiziroglou, et al., "Heat storage power supply for wireless aircraft sensors, " in Proc. PowerMEMS, Atlanta, GA, USA, Dec. 2012, pp. 472–475.

International Journal of Scientific Research in Science, Engineering and Technology

Downloads

Published

2020-04-30

Issue

Volume 7, Issue 2, March-April-2020

Section

Research Articles

License

Copyright (c) IJSRSET

Creative Commons License

This work is licensed under a Creative Commons Attribution 4.0 International License.

How to Cite

[1]
D. Meena, P. Jegan, R. Puviyarasan, R. Sathish "Design of Piezoelectric Energy Harvester and Power Conditioning" International Journal of Scientific Research in Science, Engineering and Technology (IJSRSET), Print ISSN : 2395-1990, Online ISSN : 2394-4099, Volume 7, Issue 2, pp.519-526, March-April-2020. Available at doi : https://doi.org/10.32628/IJSRSET2072102