Analysis of Machining Parameters of Endilling Cutter on Surface Roughness for Aa 6061-T6

Authors

  • Katara Hiren  UG Student, Mechanical Engineering Dept.,Sigma Institute Of Engineering,Vadodara,Gujarat,India
  • Kadam Priyanaka   
  • Vanshika Shukla   UG Student, Mechanical Engineering Dept.,Sigma Institute Of Engineering,Vadodara,Gujarat,India
  • Mr. Parth Shah  

Keywords:

end milling, ANOVA, speed, feed, depth of cut, surface roughness.

Abstract

End milling is the most commonly used milling operation. This experiment consist of numerous end milling operation on a work piece with varying different parameters like speed, feed and depth of cut. After that Analysis of Variance (ANOVA) was done on the design expert software using response surface method of design of experiment (DOE) to find out which of the parameters amongst speed, feed and depth of cut have a greater impact on surface roughness. We observed speed have a greater impact on surface roughness.

References

  1. G Boothroyd and W. Knight: Fundamentals of Machining and Machine Tools. Second Edition, Marcel Dekker Inc., New York. 1989.
  2. P Balakrishnan and M. F. De Vries: Analysis of Mathematical Model building Techniques Adaptable to Machinability Data Base System, Proceeding
  3. E M. Trent: Metal Cutting, Butterworth-Heinemann Ltd., Oxford. England, 1991.
  4. V P. Astakhov and M. O Osman: Journal of Materials Processing Technology, vol. 62, No 3, 1996, 175-179.
  5. Giunta et al., 1996; van Campen et al., 1990, Toropov et al., 1996.
  6. N Tabenkin: Carbide and Tool, vol. 21, 1985. 12-15 .g of NAMRC-XI, 1983.
  7. Parth shah: Investigation on Surface Roughness of AA 6061-T6 for End Milling,IJSTE, Volume 2 | Issue 10 | April 2016 ISSN (online): 2349-78 pg 687-690
  8. Parth Shah;Investigation on surface roughness for End Milling on Aluminium Alloy 6061-T6 for different parameters, Volume 4, Issue 01, 2016 ISSN(online):2321-0613 pg 889-893

International Journal of Scientific Research in Science, Engineering and Technology

Downloads

Published

2018-04-10

Issue

Volume 4, Issue 5, March-April-2018

Section

Research Articles

License

Copyright (c) IJSRSET

Creative Commons License

This work is licensed under a Creative Commons Attribution 4.0 International License.

How to Cite

[1]
Katara Hiren, Kadam Priyanaka , Vanshika Shukla , Mr. Parth Shah, " Analysis of Machining Parameters of Endilling Cutter on Surface Roughness for Aa 6061-T6, International Journal of Scientific Research in Science, Engineering and Technology(IJSRSET), Print ISSN : 2395-1990, Online ISSN : 2394-4099, Volume 4, Issue 5, pp.717-722, March-April-2018.