Optimization of Twist Drill Tool

Authors

  • Ms. Hase Anita V.  Mechanical Department, Savitribai Phule Pune University, SVCET, Rajuri, Maharashtra, India
  • Prof. M. S. Mali  Mechanical Department, Savitribai Phule Pune University, SVCET, Rajuri, Maharashtra, India
  • Dr. Zope S. B.  Mechanical Department, Savitribai Phule Pune University, SVCET, Rajuri, Maharashtra, India

Keywords:

Drilling Tool, Heat Treatment, Wear Test, Tool Geometry, Performance Test.

Abstract

Metal cutting processes are very important for high metal removing rate and best product quality. The cutting tool is one of the most essential elements in realizing full potential out of any metal cutting operation. The major problem in achieving high productivity and high quality is short life of tool. For increase life of cutting tool new materials with different heat treatment and different tool geometry are used. In this paper we are going to discuss optimization of drilling tool .we changed existing material of ground flute twist drill and suggesting best suitable material which performs better than existing material. We select different heat treatment cycles to find out optimum heat treatment cycle.

References

  1. Luis Miguel P Durao, Joao Manual R S Tavares, Victor Hugo C de Albuquerque, Jorge Filipe S Marques and Oscar N G Andrade (2014),”Drilling Damage in Composite Material”, Materials, Vol. 7, pp. 3802-3819
  2. Kadam M S and Pathak S S (2011), “Experimental Analysis and Comparative Performance of Coated and Uncoated Twist Drill Bit Dry Machining”, IJMERT, Vol.1, pp 33-37 
  3. Anil Jindal (2012), “Analysis of Tool Wear Rate in Drilling Operation using Scanning Electron Microscope”,JMMCE Vol. 11, No. 1, pp.43-54
  4. Yogendra Tyagi, Vedansh Chaturvedi (2012), “Optimization of Drilling machining Process using Taguchi Design and ANOVA approach ”,IJETAE, Vol. 2, Issue 7,pp.18-22
  5. Wong F R, Shari S, Kamdani K and Rahim E A (2008), “ The Effect of Drill point Geometry and drilling Technique on Tool Life when Drilling Titanium Alloy, TI6AL-4V”, International conference on Mechanical & manufacturing Engineering , May 21-23, pp.26-33
  6. Thomas G. Digges, Samuel J. Rosenberg, and Glenn W. Geil, “Heat Treatment and Properties of Iron and Steel”, National Bureau of Standards Monograph 88, Issued November 1, 1966.
  7. H.E. Boyer, Chapter 1, Practical Heat Treating, 1st ed., American Society for Metals, 1984, PP 1–16.
  8. George Krauss, ‘Steels Processing, Structure, and Performance, 2005,ASM International.
  9. Alan M. Bayer and Bruce A. Becherer, Teledyne Vasco, ‘High Speed Tool Steel”, ASM Handbook, Volume 16: Machining, Page : 51-55

International Journal of Scientific Research in Science, Engineering and Technology

Downloads

Published

2017-08-31

Issue

Volume 3, Issue 5, July-August-2017

Section

Research Articles

License

Copyright (c) IJSRSET

Creative Commons License

This work is licensed under a Creative Commons Attribution 4.0 International License.

How to Cite

[1]
Ms. Hase Anita V., Prof. M. S. Mali, Dr. Zope S. B., " Optimization of Twist Drill Tool, International Journal of Scientific Research in Science, Engineering and Technology(IJSRSET), Print ISSN : 2395-1990, Online ISSN : 2394-4099, Volume 3, Issue 5, pp.200-204, July-August-2017.