Development of Velocity Measurement Device and Calibration Using SHPB and Ballistic Impact Setup

Authors

  • Shravan R Shetty  Department of Mechanical Engineering, Vemana Institute of Technology, Bangalore, Karnataka, India
  • Rakesh S  Department of Mechanical Engineering, Vemana Institute of Technology, Bangalore, Karnataka, India
  • Manoj Kumar D  

DOI:

https://doi.org//10.32628/IJSRSET2293179

Keywords:

IR sensors, velocity measurement, Arduino, striker bar, SHPB, ballistic impact

Abstract

A velocity measurement device was developed to measure the velocity of the striker bar of Split Hopkinson Pressure Bar (SHPB) set up. It measures the range of velocity magnitudes for different size of striker bars. The velocity measurement device measures velocity of the striker bar for varying pressure values. The readings were calibrated under freefall, SHPB and also using a ballistic impact testing setup present at the authors facility. The device was developed to produce consistent readings and these readings were tabulated.

References

  1. Zhao, H., Gary, G.: On the use of SHPB techniques to determine the dynamic behaviour of materials in the range of small strains. Int. J. Solids Struct. 33, 3363-3375 (1996)
  2. Song, B. and Chen, W., 2005. Split Hopkinson pressure bar techniques for characterizing soft materials. Latin American Journal of Solids and Structures, 2(2), pp.113-152
  3. Frantz, C.E , Follansbee, P.S, Wright W.J - New experimental techniques with the Split Hopkinson pressure bar, Presented at the 8Th Intern. Conf. San Antonio, 17-21 Jun. 1984.
  4. Rohrbach, Z. J., Buresh, T. R. and Madsen, M. J. (2011) Modeling the exit velocity of a compressed air cannon. American Journal of Physics, Vol. 80, No. 1, pp 24-26
  5. Lindholm, U. S., Yeakley, L. M. (1968) High strain-rate testing: Tension and compression, SN-1741-2765 DOI - 10.1007/BF02326244
  6. M. Nabil Bassim, N. Panic, High strain rate effects on the strain of alloy steels, Journal of Materials Processing Technology, Volumes 92–93,(1999), Pages 481-485, ISSN 0924-0136, https://doi.org/10.1016/S0924-0136(99)00248-4
  7. T. Fila, “Split Hopkinson Pressure Bar: Design Parameters and Prediction of the experiment output”, 24th International conference, Engineering Mechanics 2018, Svratka , Czech Republic; paper#37; pp.213-216 doi: 10.21495/91-8-213; May 14-17; 2018

International Journal of Scientific Research in Science, Engineering and Technology

Downloads

Published

2022-07-10

Issue

Volume 9, Issue 4, July-August-2022

Section

Research Articles

License

Copyright (c) IJSRSET

Creative Commons License

This work is licensed under a Creative Commons Attribution 4.0 International License.

How to Cite

[1]
Shravan R Shetty, Rakesh S, Manoj Kumar D, " Development of Velocity Measurement Device and Calibration Using SHPB and Ballistic Impact Setup, International Journal of Scientific Research in Science, Engineering and Technology(IJSRSET), Print ISSN : 2395-1990, Online ISSN : 2394-4099, Volume 9, Issue 4, pp.55-61, July-August-2022. Available at doi : https://doi.org/10.32628/IJSRSET2293179