Implementation of Self-Checking Carry-Select Adder Based on Two-Rail Encoding in FPGA
Keywords:
Compressor, carry select Adder, Area, Delay, Area-Delay Product.Abstract
Self-checking carry-select adder design based on two-rail encoding is an efficient method, due to its arithmetic operations and short delay. This paper presents the design of the Compressor based Self-checking carry-select adder design .The circuit can detect all single stuck-at faults during on-line operation mode. Its performance is increased by using compressor by replacing all full adders.
References
- Muhammad Ali Akbar and Jeong-A Lee," Comments on "Self-Checking Carry-Select Adder Design Based on Two-Rail Encoding", vol. 61, no. 7, july 2014
- D. P. Vasudevan, P. K. Lala, and J. P. Parkerson, "Self-checking carry select adder design based on two-rail encoding," IEEE Trans. Circuits Syst. I, Reg. Papers, vol. 54, no. 12, pp. 2696-2705, Dec. 2007.
- Hamdi Belgacem, Khedhiri Chiraz and Tourki Rached, "A novel differential XOR-based self-checking adder", Vol. 99, No. 9, September 2012, 1239-1261.
- Sanjeev Kumar and Manoj Kumar, "Low Power High Speed 3-2 Compressor" International journal of Electrical, Electronic and Mechanical controls ISSN (online): 2319-7509
Downloads
Published
Issue
Section
License
Copyright (c) IJSRSET

This work is licensed under a Creative Commons Attribution 4.0 International License.