Design and Analysis of Standalone PV based Boost Converter With P & O MPPT Technique

Authors

  • Priyanka Yadav  Electrical and Electronics Engineering, RGPV, M.I.T, Indore, Madhya Pradesh, India
  • Menka Dubey  Electrical and Electronics Engineering, RGPV, M.I.T, Indore, Madhya Pradesh, India

Keywords:

MPPT (Maximum Power Point Tracking), P&O (Perturb and Observe), PV (Photovoltaic), Boost Converter

Abstract

This paper deals with the design and analysis of standalone solar PV based boost converter with P& O (Perturb and Observe) MPPT (Maximum Power Point Tracking) Techniques. An intermediate converter can therefore increase efficiency by matching the PV system to the load and by operating the solar cell arrays at their maximum power point. MPPT (Maximum Power Point Tracking) controller is used for extracting the maximum power from the solar PV module. P&O (Perturb and Observe) MPPT (Maximum Power Point Tracking) is used because of simple implementations. The proposed converter system results in low ripple content, which improves the array performance. Solar PV stand–alone system with boost converter is modeled in MATLAB/SIMULINK environment using the sim power system toolboxes. The performance of the proposed system is obtained in both dynamic and steady states.

References

  1. A. Khaligh and O.C. Onar , Energy harvesting solar, wind, and ocean energy conversion  systems, CRC Press, New York, 2010.
  2. N. Femia, G. Petrone, G. Spagnuolo and M. Vitelli, “Optimization of perturb and observe maximum power point tracking method,” IEEE Trans. Power Electronics, vol. 20, no.4, pp. 963-973, July 2005.
  3. P. K. Chaudhary and R. Maheshwari, “A Critical review on photovoltaic base maximum power generation system,” International Journal of Recent Technology and Engineering (IJRTE), vol-1, no 6, pp. 51-62 Jan 2013
  4. J. Suryakumari, G. Sahiti and G. Sudhakar, “Analysis and simulation of perturb and observe MPPT technique,” International Journal of Engineering Research and Applications (IJERA), vol. 3, no.4, pp.1662-1668, Jul-Aug 2013.
  5. P. Sharma, and V. Agarwal, “Exact maximum power point tracking of Grid-Connected partially shaded PV source using current compensation concept,” IEEE Trans. Power Electronics, vol. 29, no. 9, pp. 4684-4692, Sept 2014
  6. A. N. Allah, M. H. Saied and M. Z. Mostafa, “A survey of maximum PPT techniques of PV systems,” IEEE Trans. energy conversion, vol.55, no. 7, pp. 2622-2628, may 2012.
  7. I.V. Banu, R. Benluga and M. Istrate, “Comparative analysis of the perturb and observe and incremental conductance MPPT methods,” International Symposium advanced topics in electrical engineering, May 23-25, 2013.
  8. R. Meena, “Simulation study of boost converter with various control techniques,” International Journal of Science and Research (IJSR), vol.3 no 9, pp. 74-79, sep 2014.
  9. M. S. Sivagamasundari, P. M. Mary and V. K. Velvizhi, “Maximum power point tracking for photovoltaic system by perturb and observe method using buck boost converter,” International Journal of Advanced Research in Electrical, Electronics and Instrumentation Engineering, vol. 2, no. 6, pp. 2433-3439, June 2013.
  10. T. Esram, and P. L. Chapman, “Comparison of photovoltaic array maximum power point tracking techniques,” IEEE Trans. energy conversion, vol. 22, no. 2, pp. 439-449, June 2007.

Downloads

Published

2016-02-25

Issue

Section

Research Articles

How to Cite

[1]
Priyanka Yadav, Menka Dubey, " Design and Analysis of Standalone PV based Boost Converter With P & O MPPT Technique, International Journal of Scientific Research in Science, Engineering and Technology(IJSRSET), Print ISSN : 2395-1990, Online ISSN : 2394-4099, Volume 2, Issue 1, pp.165-169, January-February-2016.