Fabrication of a Bicycle without a Chain

Authors

  • K. Pandit  Mechanical Department, Lords Institute of Engineering and technology, Hyderabad, Telangana, Andhra Pradesh, India
  • Pralhad Kumar. M. Hadanoor  Mechanical Department, Lords Institute of Engineering and technology, Hyderabad, Telangana, Andhra Pradesh, India
  • S. Suneer Basha  Mechanical Department, Lords Institute of Engineering and technology, Hyderabad, Telangana, Andhra Pradesh, India
  • M. Ujwal Kumar  Mechanical Department, Lords Institute of Engineering and technology, Hyderabad, Telangana, Andhra Pradesh, India

Keywords:

Drive Shaft, Bevel Gear, Fabrication

Abstract

This work is developed for the users to rotate the back wheel of a two wheeler using propeller shaft. Usually in two wheelers, chain and sprocket method is used to drive the back wheel. But in this project, the Engine is connected at the front part of the vehicle. The shaft of the engine is connected with along rod. The other side of the long disconnected with a set of bevel gears. The bevel gears are used to rotate the shaft in 90o angle. The back wheel of the vehicle is connected with the bevel gear (drive). Thus the back wheel is rotated in perpendicular to the engine shaft. Thus the two wheeler will move forward. According to the direction of motion of the engine, the wheel will be moved forward or reverse. This avoids the usage of chain and sprocket method.

References

  1. Rastogi, N. (2004). Design of composite drive shafts for automotive applications. Visteon Corporation, SAE technical paper series.
  2. Design and Analysis of a Propeller Shaft of a Toyota Qualis by “Syed Hasan”.
  3. A.M.Ummuhaani and Dr.P.Sadagopan “Design, Fabrication and Stress Analysis of a Composite Propeller Shaft, 2011-28-0013.
  4. Anup A. Bijagare, P.G. Mehar and V.N. Mujbaile “Design Optimization & Analysis of Drive Shaft”, Vol. 2(6).
  5. Rangaswamy, T.; Vijayrangan, S. (2005). Optimal sizing and stacking sequence of composite drive shafts. Materials science, Vol. 11 No 2., India.
  6. Rastogi, N. (2004). Design of composite drive shafts for automotive applications. Visteon Corporation, SAE technical paper series

International Journal of Scientific Research in Science, Engineering and Technology

Downloads

Published

2017-04-30

Issue

Volume 3, Issue 2, March-April-2017

Section

Research Articles

License

Copyright (c) IJSRSET

Creative Commons License

This work is licensed under a Creative Commons Attribution 4.0 International License.

How to Cite

[1]
K. Pandit, Pralhad Kumar. M. Hadanoor, S. Suneer Basha, M. Ujwal Kumar "Fabrication of a Bicycle without a Chain" International Journal of Scientific Research in Science, Engineering and Technology (IJSRSET), Print ISSN : 2395-1990, Online ISSN : 2394-4099, Volume 3, Issue 2, pp.422-428, March-April-2017.