Underground Cable Fault Detection System

Authors

  • A. S. Pawar HSBPVT'S GOI Faculty of Engineering, Kashti, Maharashtra, India Author
  • S. N. Sondkar HSBPVT'S GOI Faculty of Engineering, Kashti, Maharashtra, India Author
  • S. G. More HSBPVT'S GOI Faculty of Engineering, Kashti, Maharashtra, India Author
  • V. B. Tarate Assistant Professor, HSBPVT'S GOI Faculty of Engineering, Kashti, Maharashtra, India Author

Keywords:

Arduino Uno, Step Down Transformer, LCD

Abstract

This work Underground Cable Fault Detector is used for identifying faults in the underground cable. Underground cables are prone to a wide variety of faults due to underground conditions, wear and tear, rodents etc. Diagnosing fault source is difficult and entire cable should be taken out from the ground to check and fix faults. The project work is intended to detect the location of fault in underground cable lines from the base station in km using a Arduino microcontroller. To locate a fault in the cable, the cable must be tested for faults. This prototype uses the concept of Ohms law. The current would vary depending upon the length of fault of the cable. In the urban areas, the electrical cable run in underground instead of overhead lines. Whenever the fault occurs in underground cable it is difficult to detect the exact location of the fault. The prototype is modelled with a set of wires representing cable length in km and fault creation is made by a set of switches at every known distance to cross check the accuracy of the same. In case of fault, the voltage across series wires changes accordingly, which is then fed to an ADC to develop precise digital data to a programmed Arduino that further displays fault location in distance. The fault occurring distance is displayed on a 16X2 LCD interfaced with the microcontroller.

Downloads

Download data is not yet available.

References

Abhishek Pandey, Nicolas.H, Younan, “Underground Cable Fault Detection and Identification via Fourier Analysis”, 2010 IEEE.

Xia Yang, Student Member, Myeon-Song Choi, Member, Seung-Jae Lee, “Member, Fault Location for Underground Power Cable Using Distributed Parameter Approach” 2008.

A.Ngaopitakkul, C.Pothisarn, M.Leelajindakrairerk,(2011), “Study of Characteristics for Simultaneous Faults in Distribution Underground Cable using DWT”, 2011 IEEE.

Mr. M. R. Hans, Ms. Snehal C. Kor, Ms. A. S. Patil (2017), “Identification of underground cable fault location and development”

Tarlochan S. Sidhu, Zhihan Xu, “detection and classification of incipient faults in underground cables in distribution systems”.

Downloads

Published

12-04-2024

Issue

Section

Research Articles

How to Cite

[1]
A. S. Pawar, S. N. Sondkar, S. G. More, and V. B. Tarate, “Underground Cable Fault Detection System”, Int J Sci Res Sci Eng Technol, vol. 11, no. 2, pp. 256–259, Apr. 2024, Accessed: Nov. 07, 2024. [Online]. Available: https://ijsrset.com/index.php/home/article/view/IJSRSET2411238

Similar Articles

1-10 of 13

You may also start an advanced similarity search for this article.